Donning the respirator:

1. Before putting on the respirator, wash hands for at least 20 seconds with soap and water or rub hands together thoroughly with alcohol-based hand sanitiser.
2. Take care not to touch the inside layer of the respirator that will be in contact with the nose and mouth when unpacking and while donning.
3. Check for defects in the face respirator such as tears or broken loops.
4. Position the label side of the respirator outward and orient the respirator so that the foam nose bridge strip is at the top.
5. Unfold the respirator while holding onto the edges (again being careful not to touch the area that will be in contact with the nose and mouth). Position the unfolded respirator over the nose and mouth and place one ear loop over each ear.
6. Mould the nose bridge wire to the bridge of the nose and while pinching the nose bridge in place stretch the bottom of the respirator to over the chin. Press along the edges of the respirator to maximise the seal.
7. Avoid touching the respirator while using it; if touched, clean hands with hand sanitiser or soap and water. 
8. Replace respirator if it becomes obviously contaminated; never reuse single-use respirators.

Removing the respirator:

1. Wash hands with soap and water or hand sanitiser before removing the respirator.
2. Remove the respirator by unhooking the ear loops, taking care not to touch the front of the respirator which might have become contaminated.
3. Discard immediately in a closed bin and clean hands with hand sanitiser or soap and water.

Expiry: January 2025

To view our headband mask sizing guide, click HERE

• Brand: AMD
• Number per Box: 50 (small and medium-sized headband masks) & 25 (large-sized headband masks
• Packaging: Bulk Case
• Filter Included: Yes
• Face seal/Nose foam: Contains nose foam
• Fluid Resistant (ASTM F1862): No
• Flame Resistance (ASTM D2859-96): No
• Flammability Rating: Class 1
• Product Colour: White
• Product Type: Dust and other Particles
• Respirator Style: Flat Fold
• Size: Standard
• Australia and New Zealand Compliance Standards: P2
• Standards/Approvals: AS/NZS 1716:2012
• Certification/Class: P2
• Filter performance: ≥ 99.6%
• Test agent: NaCl
• Flow rate: 95 L/min
• Total inward leakage (TIL): ≤ 8% leakage
• Inhalation resistance: ≤ 70 Pa (at 30L/min), ≤ 240 Pa (at 95L/min)
• Flow rate: Varied – see above
• Exhalation resistance: ≤ 120 Pa
• Flow rate: 85L/min
• Exhalation valve leakage requirement: Leak rate ≤ 30mL/min
• Force applied: -250 Pa
• CO2 clearance requirement: ≤ 1%

Features

• Australian Made
• Cutting-edge nanofibre filters
• Four-layers with elastic ear loops
• Innovative three-panel design improves fit and aesthetic and minimises gaps
• High breathability
• Soft, lightweight, comfortable & odourless
• Individually packed
• Latex free

Packaging details

WEIGHT: 0.6 kg

DIMENSIONS: 26 × 25 × 12 cm

Each AMD P2 Mask is individually wrapped and sealed.

T4HL Headband face mask measurements:

a) Top panel height: 5.9cm

b) Middle panel height: 8.5cm

c) Middle panel length: 22cm

d) Bottom panel height: 7.5cm

e) Nose wire: 10.5cm

3mm height- nose wire

Click here for Certifications and Reports.