Use is for liquid medication nebulisation only

For first use

1. Clean, disinfect and dry all of the parts (See Cleaning directions below).
2. Charge the device (See Charging directions below)

How to use the portable nebuliser

1. Remove the lid on the medication cup.
2. Fill to below the max 10ml capacity.
3. Close the lid. 
4. Attach the mouth piece or mask if desired. 
5. Click the blue ON/OFF switch to start (pull the slider down for access to the switch).
6. Hold the nebuliser vertical to keep the liquid in contact with the mesh.
7. Take slow deep breaths to inhale the medication. 
8. After 10 minutes, the device will automatically shut off. If longer use is desired, simply switch the device on again. Ensure that there is enough liquid medication in the device before use. 
9. NB: When finished, nebulise with 3ml of warm water. Once a week, nebulise with a mix of 3ml of warm water and 1ml of vinegar. Press the ON/OFF switch to turn off. 
10. Detach the medication cup by pushing the ‘press’ button behind the device and pull the medication cup upwards. Dispose of any medication.
11. Clean any accessories that were used during nebulisation.

Charging

1. Charge the device using the provided USB charging cable - if using a standard adapter, make sure it complies with IEC 60601-1, 5.0V.
2. The device is usable whilst charging.
3. The device takes approximately 1 hour to fully charge.
4. When the device is on low battery it will flash slowly.
5. Please charge the device at least once a month, even when not in use.

Cleaning

1. Remove the medication cup, lid, mouthpiece or mask from the device.
2. Submerge and hand wash in luke warm water (no more than 50°C) for about 5 minutes. 
3. Set aside to dry in a clean place, and if required, disinfect (See Disinfection directions below).

Disinfection (if required)

1. Place the cleaned medication cup, lid, mouthpiece or mask in a disinfectant solution OR steam sterilise in a standard baby steam device as per device instructions. 
2. Air dry completely after disinfecting. 

⚠️ Maintenance Tip:

To ensure uninterrupted performance, it’s essential to keep the connection between the medication cup and the device clean and dry. Any build-up or corrosion can interfere with the electrical signal, causing the nebuliser to appear powered on but not nebulising.

If this occurs, inspect the pins and plates. Gently scrape off any corrosion using a small pin or similar tool to restore proper contact and functionality. Regular maintenance will extend the life of your device and maintain treatment efficiency.

We recommend replacing the medication cup every 3 to 4 months, especially with regular use, as wear over time can affect nebulisation quality.

Storage

Store the device in the provided carry case ensuring the following:

• The temperature is between -2°C and 55°C
• The relative humidity is less than 80%.
• Atmospheric pressure is between 70 and 106 kPa.
• The device is not in storage for 5+ years unused.

Contents

• Lid x1
• Device x1
• Medication cup x1
• Mouthpiece x1
• Mask x2 (for adult x1, child x1)
• Travel case x1
• USB charging port x1

Technical specifications

• MMAD of 2.5μm - 4.5μm
• Nebulisation rate of 0.3ml/min - 9.7ml/min

Warranty : 3 month warranty on the removable head and 12 month warranty on the body. (thats on the e-chamber website)