1. Place head bands toward the front of the mask. Open the mask, creating a gentle curve in the nose wire. 
2. Place hand at the base of the mask (gripping the front seal making sure the bands sit above your hand). 
3. Lean chin into the mask and pull over the bottom band to rest around your neck below the ears. Pull over the top band and position at the crown of the head. 
4. Position the mask nose piece above the nasal flares. The mask should sit on the soft area of the nose rather than on the bone of the nose. 
5. Adjust mask bands for a secure and comfortable fit. 
6. Using your index finger, hold firmly on the nose wire in the centre of the nose, while using your other index finger and thumb in a pinching motion to firmly mould the nose wire over the bridge of the nose.
7. Once the mask is firmly moulded to the nose, using one hand, firmly pinch on the nose wire low on the nasal flares of the nose and gently drop your bottom jaw. This will allow the respirator to fit the natural shape of your face, resulting in a better seal.
8. Look left to right, then up and down. There is to be no movement of the mask at the nose wire. 
9. Inhale and exhale deeply, checking for escape of air. Remember, once the respirator is applied it should not be touched or reapplied.

Tips: If you notice an immediate gap between the side of the face and the mask, it may be that the strap needs to be adjusted. This can be done by lowering the bottom strap behind the ear. If a gap is still present after lowering your strap a different size mask may be required.

Brand: Detmold

Colour: White

Country of origin: Australia

Type: Latex-free, Non-sterile

ARTG #382970